Popular Articles
"Difference is too small" message (during calibration)
The reason for the message is that the change in analogue output from the scale base between zero calibration and the span calibration value is too small. The most likely reason is that the amount of weight placed on the scale for span calibration is ...
Changing display from kg to lb
Press and hold the F4 key down to get into the configuration menu (Dip switch 1 needs to be on, located under the small back cover on the rear of the indicator). Under the scale menu, scroll down using the F3 button until you find the menu "Allow ...
Changing display from kg to lb
Press and hold the F4 key down to get into the configuration menu (Dip Switch 1, located under the small back cover on the rear of the indicator, has to be on). Under the scale menu, scroll down using the F3 button until you find the menu "Allow ...
How to put the operator panel into “Stream” mode
1. Hold the F4 button to enter the Setup menu 2. Scroll down to RS-232 using F4 button 3. Select using M- key 4. With “Output” highlighted and using F2 key to scroll up or F3 key to scroll down, scroll to “Stream” 5. ...
Polling the ABS960+ for data
The computer at the check-in desk interfaces with the OP-960+ to capture the weight for each of the bags. The computer connection is local and uses the RS-232 port of the operator panel. To pull the weight for their check-in system from the operator ...